Home › Floor structure › Floor joist diagram: how the framing under your floor fits together

Floor joist diagram

Picture the floor as a layered stack. Once you can name each layer, you can tell what you are looking at from below.

A floor joist diagram shows a row of parallel boards (the joists) resting on a beam at the middle and on the sill plate at the edges, with the subfloor laid across the top. Everything else in the floor system hangs off that basic stack.

This page prints no prices and does not recommend a brand or a company. It gives you the vocabulary to read what you see from a basement or crawl space.

The stack, from the top down

Finish flooring sits on the subfloor, usually plywood or boards. The subfloor is fastened to the joists, which run in one direction across the house. Joists rest on a beam near the middle and on the foundation wall at the ends. Beam and wall pass the load down to piers, posts or the foundation itself.

Where the edges connect

The sill plate is the wood that lies on top of the foundation wall. The joists sit on it, and a rim joist closes off the ends of the joists around the perimeter. This is the spot closest to the soil and the outside air, so it is also where moisture and pests get in first. See sill plate rot for what damage looks like.

Reading the joists from below

Look for a dark stain, a soft spot when you press with a screwdriver tip, a long split, or a notch or hole cut for a pipe. Small holes drilled near the middle of the joist height are usually fine. Large notches in the top or bottom edge are a different story. Our floor joist repair page explains what repair involves.

Bridging and blocking

Small cross pieces between joists, called bridging or blocking, keep the joists from twisting. If they are missing or loose, the floor can feel bouncy. The bouncy floors page covers that symptom.

What a diagram cannot tell you

Real houses rarely match the textbook drawing. Old houses may use true-dimension lumber, odd spacing or a notched beam. A drawing cannot show you whether a joist is carrying more than it should.

Do not cut, drill or sister joists on a guess

Changing a joist changes how the whole floor carries load. Sistering floor joists is explained here only so you can follow a proposal. Any change to the structure should be specified by a licensed structural engineer, and your local building department can tell you what permit applies.

Frequently asked questions

What is a floor joist?

A horizontal board that runs across the space under a floor and carries the subfloor and everything on it.

What do floor joists rest on?

They rest on the sill plate on top of the foundation wall at the ends and on a beam or girder near the middle.

What is a rim joist?

The board that caps the ends of the joists around the edge of the house. It sits close to the soil, so moisture and pests often reach it first.

Is it safe to drill holes in a floor joist?

Small holes in the middle of the joist height are often acceptable, but large notches are not. Ask a licensed structural engineer before cutting anything.

How do I tell whether a joist is damaged?

Look for stains, soft wood when probed, long splits and large notches. Then ask a professional to assess it.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading