Home › Floor structure › Floor joist sagging: what makes the frame dip and who decides the fix

Floor joist sagging

A dip in the floor often starts in the frame under it. Here is how to see what is happening from below.

When a floor joist sags, the floor above follows it down. The usual causes are moisture, a support that moved or failed, a joist that was undersized or cut, and years of heavy load.

This page prints no prices and does not recommend a brand or a company. It explains what to look for so you can decide who to call.

Start from below

If you have a basement or a crawl space, look up at the joists with a flashlight. A joist that curves downward between its supports is sagging. Lay a long straight board against the bottom edge, or stretch a string tight from one end to the other, and see how far the joist drops away. Take dated photos. You will want them if an engineer visits.

Moisture is the first suspect

Wet wood loses stiffness. A damp crawl space, a leaking pipe or a wet foundation wall can soften joists over months or years. Press a screwdriver into the wood in a hidden spot. If it goes in easily, the wood is soft. Describe dark staining as growth and as a sign of persistent damp, and do not call it a confirmed type of mold. A qualified third party confirms what it is by sampling. Fix the water first. See subfloor water damage for the signs.

Look at what holds the joist up

A joist can look fine and still dip because its support moved. Check the beam, the piers or posts and the sill plate where the joists end. A post that has sunk, a pier that has tilted or a rotted sill will let the joist drop. The joist then looks like the problem when the support is. Our page on sagging floors over a crawl space goes through the supports in more detail.

Cuts, notches and old overloading

Joists get notched for pipes and drilled for wiring. Cut in the wrong place, they lose strength and start to dip. A joist can also sag slowly under a heavy load it was never meant to carry. Some of that sag is permanent. Wood that has taken a set does not spring back when the load is removed.

Why the fix is not a weekend job

Sagging joists are structural. A licensed structural engineer should decide whether the answer is sistering, a new support, a repair to the foundation end or full replacement. Ask for one who does not sell the repair, so the diagnosis is independent. Do not jack the floor up yourself. Raising it too fast can crack plaster, break pipes and stress the frame further.

Ask your local building department what permits apply where you live. You can read how the common repairs work in sistering floor joists and replacing a floor joist, so you understand what an engineer proposes.

Frequently asked questions

What causes floor joists to sag?

Moisture and rot, a support that sank or failed, undersized or notched joists, and long-term overloading. Check the supports as well as the joist.

How can I tell if a joist is sagging?

Look up at it from below. Hold a straight board or a taut string along the bottom edge and see how far the joist drops away from it.

Can sagging joists be fixed?

Often, but the method depends on the cause. A licensed structural engineer decides between sistering, new supports or replacement.

Is a sagging joist an emergency?

Not always, but a growing sag, soft wood or cracking should be checked soon. Keep heavy loads off the area until it has been looked at.

Should I jack up a sagging floor?

No, not on your own. Lifting too fast can damage the frame and the finishes. Leave that to the repair plan from an engineer.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading