Home › Waterproofing › Crawl space encapsulation system: what is in it and what to check

Encapsulation system

The liner gets the attention. The air control and the leak fix underneath it decide whether the system works.

A crawl space encapsulation system seals the space off from the soil and the outside air, using a liner on the floor and walls, taped seams and usually some way to control humidity. The parts matter less than whether they are all there.

This page prints no prices and does not recommend a brand or a company. It lists what a system normally contains so you can read a proposal.

The liner on the floor and walls

A heavy plastic liner covers the soil and runs up the walls and around piers. Seams overlap and are taped or sealed. This is the core of the system. A plain sheet on the ground alone is closer to a vapor barrier than to encapsulation.

Sealed vents and rim openings

Foundation vents are closed off, and gaps at the rim are sealed so outside air stops flowing through. Whether that suits your house depends on climate and local code. The vents open or closed page explains the trade-off.

Air and humidity control

Once the space is sealed, moisture still has to go somewhere. Systems usually add a dehumidifier or conditioned air from the house. Without it, a sealed space can stay damp. See dehumidifying a crawl space.

Water management comes first

A liner does not stop liquid water. If the space floods or the soil stays wet, the water needs a way out before anything is sealed over it. A system installed on top of an active leak hides the problem.

What a proposal should spell out

Ask for each part in writing: liner type and where it runs, how seams are sealed, what happens to vents and the rim, and what controls humidity. Ask how the wood will be checked before it is covered. A proposal that just says encapsulation is not a proposal.

When it is not worth doing yet

If the crawl space is already dry, the ground is covered and the wood is sound, a full system may add little. Also hold off if there is damaged framing. That needs to be assessed first, and anything structural goes to a licensed structural engineer.

Local rules vary

Rules on vents, combustion appliances and permits differ by state and city. Ask your local building department what applies. The encapsulation explained page gives the wider picture.

Frequently asked questions

What is in a crawl space encapsulation system?

A liner over the floor and walls, sealed seams, closed vents and rim gaps, and usually a way to control humidity.

Is a vapor barrier the same as an encapsulation system?

No. A ground sheet alone does not seal the walls, vents or air.

Does an encapsulation system stop water?

It does not fix liquid water. Drainage or leaks need to be handled first.

Is a dehumidifier required?

Many systems include one or condition the air some other way. Without it a sealed space can stay damp.

Do I need a permit?

Rules are local. Your building department can tell you.

Sources

What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.

Keep reading