Interior waterproofing system
It manages water after it gets in. It does not keep water out of the wall.
An interior waterproofing system catches water at the bottom of the basement wall and moves it to a sump pit, where a pump sends it outside. It manages water that is already inside the foundation. It does not stop that water from reaching the wall.
This page prints no prices and does not recommend a brand or a company. It lists the parts so you can read a proposal.
The drain channel along the floor edge
A channel is set in a trench cut along the inside of the footing, where the floor meets the wall. Perforated pipe sits in gravel inside it. Water that seeps through the wall or up at the joint drops into the channel instead of spreading across the slab.
The sump pit and pump
The channel slopes toward a pit set below the floor. A pump lifts the water out and discharges it away from the house. The pump is the part that fails, so power cuts matter. Read why sump pumps fail before you rely on one.
Wall sheeting along the lower wall
Some systems add a dimpled plastic sheet on the lower wall. It guides seepage down into the channel and keeps wet masonry from touching the finished side. It is not a coating and it does not seal the wall.
What an interior system cannot do
It cannot lower the pressure outside the wall. Soil stays saturated, and the wall stays wet behind the sheet. If the real cause is roof water or poor grading, fix that first. The interior vs exterior waterproofing page compares the two approaches.
Why it is common anyway
Working inside means no excavation, no digging up a patio and no disturbing landscaping. For many houses it is the practical option. It suits a wall that is sound and a problem that is seepage rather than movement.
When to stop and call an engineer
If the wall is cracked and shifting, bowing or leaning, a drain channel treats the wrong problem. Water is a symptom there. Movement is assessed by a licensed structural engineer, ideally one who does not sell the repair.
What a proposal should spell out
Ask where the channel runs, how deep, where the pit sits, what the pump discharges into, and what backup exists when the power goes out. Ask what happens to the wall behind it. Vague wording is a reason to ask again. Rules on discharge and permits are local, so check with your building department.
Frequently asked questions
What is an interior waterproofing system?
A drain channel along the inside of the footing, a sump pit and a pump that collect seepage and send it outside.
Does an interior system stop water entering the wall?
No. It collects water that has already come through and removes it.
Does it need electricity?
Usually, because the pump runs on power. Ask what happens during an outage.
Can it fix a bowing wall?
No. Movement is a structural question for a licensed structural engineer.
Do I need a permit?
Rules are local. Your building department can tell you.
Sources
What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.