Types of floor joist
The framing under your floor may be old lumber or a modern engineered product. Each one reacts to moisture in its own way.
Floor joists come in four common types: solid sawn lumber, I-joists, open-web trusses and engineered lumber such as laminated veneer lumber (LVL). You can usually tell which you have by looking up from a basement or crawl space.
This page prints no prices and does not recommend a brand or a company. It helps you name what you see.
Solid sawn lumber
These are plain rectangular boards, often 2x8, 2x10 or 2x12. They are found in most older houses. Look for a rough or planed surface and the grain running along the board. Moisture shows up as dark stains, soft spots and splits.
I-joists
An I-joist has a thin web, often made of OSB, between two flanges. It is light and straight. Holes in the web are only allowed in set places, so a random hole cut for a pipe is a concern. A wet web can swell and weaken.
Open-web trusses
Trusses are built from top and bottom chords joined by diagonal pieces, leaving open space for pipes and ducts. Metal plates or fasteners hold the pieces together. Check that no plates are loose or rusted and that no diagonal piece has been cut.
Engineered lumber
LVL and similar products are made by gluing layers of wood. They are used for beams and some joists. They are strong, but they should not stay wet, and cutting or notching them is not allowed without an engineer.
Why it matters for damp spaces
Solid lumber tolerates a short wetting better than a thin I-joist web. No type does well in a space that is always damp. Look at the floor joist diagram to see where each piece sits.
Do not cut or drill them
Notches and holes that are fine in one type can ruin another. Before anything is changed, ask a licensed structural engineer. If you see damage, floor joist repair explains how it is usually approached. Your local building department can answer code questions, since rules vary by area.
Frequently asked questions
What are the main types of floor joist?
Solid sawn lumber, I-joists, open-web trusses and engineered lumber such as laminated veneer lumber (LVL).
How can I tell an I-joist from a regular joist?
An I-joist has a thin vertical web between a top and a bottom flange, so its profile looks like the letter I.
Which type of joist is most affected by moisture?
All of them lose strength if they stay wet. The thin web of an I-joist can swell, and solid lumber can rot.
Can I drill holes in any floor joist?
No. Allowed holes depend on the type and location. Ask a licensed structural engineer before cutting or drilling.
Why do some floors have open-web trusses?
They span long distances and leave space for pipes and ducts between the pieces.
Sources
What this page explains is based on these official sources. If you check one and it does not match what you read here, send it to us and the article gets corrected.